INSTALACIÓN ELÉCTRICA, automatismo llenado de tanque y cisterna monofásico

INSTALACIÓN ELÉCTRICA, automatismo llenado de tanque y cisterna monofásico

SUBTITLE'S INFO:

Language: English

Type: Robot

Number of phrases: 67

Number of words: 632

Number of symbols: 2626

DOWNLOAD SUBTITLES:

DOWNLOAD AUDIO AND VIDEO:

SUBTITLES:

Subtitles generated by robot
00:03
well in this video we are going to make a automation and control system of a tank filling the first is given in triphasic form this video will be performed in a single-phase manner it is quite simple to perform any person who has a minimum of knowledge can be done we have the elements that make up the motive force or power system the thermomagnetic contactor and a relay thermal L1 or refers to phase or brown wire phase R and the blue to the neutral there is another way to perform too the connections of the contactor part of power I do it from this way to make it a little more visible
01:16
the connection we have the connection of the thermal relay towards the motor in the new thermal is the in charge of protecting the engine in case of over current or in case of low tension it is assumed that if there is low voltage the current rises we also have the grounding terminal block where the ground wire what it does is connect to the engine chassis to drain leakage currents we see tanks entering and the selector the selector has two positions 0 and 1 for is in shape automatically in automatic 1 a Handbook the tank switch contacts are reflected at the top
02:43
from the tank well and for this we are going to use a transformer the voltage that we are going to drive is going to be 24 volt to get 24 volt we need a transformer the transformer has to be 220 volt at 24 volt is a step-down transformer the neutral in the 24 volt part is feed to the coil the contactor and phase 24 goes through contact normal closed thermal relay for then go out and connect to the common selector well in this case we have to tank cistern is full if the tank is full float contact will be closed It is a condition that must be had
04:09
that the cistern tank so that this system works well it has to be always full the service tank is open because because the tank is full now what we are going to see is the connection of contacts of tank automatics is nothing more than a series circuit if you fix It is a series the service tank contact is open because it's full when the water is emptied the contact is is going to close and send a signal to contactor to run the pump when the tank is filled what will be the contact will open to send signal
05:43
contactor to stop the pump operation the system is quite simple what we have here it the signaling pilots the green will be when the contact of the selector is at 0 is at automatic the green light will turn on now in manual case the red light is going to turn on because we use this 24-hour care volt because in the automation part there is a regulation that says that all the automation made have to be so that it is low to tension well this is quite simple we continue what we have here is the
07:17
an outline does not show the types of boards there are for pumps you can see the tank switch contacts which has two positions NO and NC and in that the use will depend on the installer agreed the automation you want to do we have the selector the selector in this case has three positions 1 - 0 and 2 we use 1 and 2 well this quite simple does not require of much complexity we see here in the pipes and valves of an installation of toilets and well, I'll leave you, it's just here

DOWNLOAD SUBTITLES: