Guage2

Guage2

SUBTITLE'S INFO:

Language: English

Type: Robot

Number of phrases: 66

Number of words: 486

Number of symbols: 1997

DOWNLOAD SUBTITLES:

DOWNLOAD AUDIO AND VIDEO:

SUBTITLES:

Subtitles generated by robot
00:00
good gage operation turn slide on okay and the lower-right gives your trips your hours and odometer and the clock to set the trip to zero you just hold the lower right button
00:31
that sets it to zero to set the clock you hold the button then you go over to the left-hand button and using the arrows you can select either 12 or 24 hour either way then you can change your
01:07
numbers as Sol down arrow goes back up goes up and hit the set button again then you can change your minutes and then you're back then that should be it for that button then the upper right you can move your clock up to there that shows zero Tim
01:54
meter and our p.m. if you want to move your your rpm over and your mile-per-hour to the right you just hit the left upper button then mile-per-hour is on the right rpm is on the left now for the the lower-left the coolant temperature volt intake air or nothing
02:32
if you prefer to just have the bar showing and no numerical value you just hold the button and it goes away or if you hold the button again there it is and that applies to every values shown then for your altimeter you alts you
03:02
also need to figure out what your your your elevation is so you go on the phone or whatever and it it's easy to google it so you hold the bat button and then you can change your your LT meter it needs a a base setting in order to be accurate then you can go in also in the Diagnostics mode to go in diagnostics
03:35
mode you hold both the left and right lower buttons at the same time this the pd sr pin does not apply to us so on our tcats when you were when you buy this sled before the sled leaves the store
04:06
they have to tie enter a pin number ours are always all zeros so in order go in diagnostic mode its slapped you got throttle position sensor which should be at zero at idle and when you're wide open should be very close to a hundred percent I'm changing the throttle right I'm giving a gas and letting off right now then you have your
04:46
barrel reading and your idle speed control that's just a value that changes as it warms up you'll see you'll see it change and that is a home reading off your fuel pump that also changes as when it's running and as you're giving a gas and you can have this diagnostic mode running while the sled is is actually
05:18
being operated and that's it for diagnostic mode in order to exit you scroll up exit select I don't know why it makes you wait but it does so that's your gauge operation Thanks

DOWNLOAD SUBTITLES: